Videos

This video will demonstrate how to properly set the Sentinel Modbus to read registers from an attached Modbus device and set the data type for each register. It will also so how to validate the registers being polled

1 0

In this video , you will learn how to setup the Modbus table using the SignalFire Cloud web app

1 1

This video will show you how to configure logic in the gateway to be triggered based on node measurements

1 2

This video educate how to properly setup the Sentinel HART to communicate with a HART device. This shows how to set with the ToolKit the HART address to 1, how to set the Sensor On Time to wake up a HART device and to read the 4 dynamic HART variables (PV,SV,TV,QV)

0 0

It is possible when flashing a 900MHZ node to have it stuck in Bootloader mode. This video shows how to reflash the memory to get the device out of Bootloader

0 0

It is possible when flashing a 900MHZ node to have it stuck in Bootloader mode. This video shows how to reflash the memory to get the device out of Bootloader

0 0

This video teaches how to setup two Wireless I/O modules in point-to-point mode where the inputs/outputs from one modules is mirrored on the another module.

1 0

This video will show you how to configure the Pulse Output on a ModQ to interface with a RANGER such that you can monitor in the Cloud the ModQ

1 0

1 0